Log Replay

recovery_time_target

Parameter description: Specifies the time for a standby server to write and replay logs.

This parameter is a SIGHUP parameter. Set it based on instructions provided in Table 1 GUC parameters.

Value range: an integer ranging from 0 to 3600. The unit is second.

0 indicates that log flow control is disabled. A value from 1 to 3600 indicates that a standby server can write and replay logs within the period specified by the value, so that the standby server can quickly assume the primary role. If this parameter is set to a small value, the performance of the primary server is affected. If it is set to a large value, the log flow is not effectively controlled.

Default value: 0

recovery_max_workers

Parameter description: Specifies the maximum number of concurrent replay threads.

This parameter is a POSTMASTER parameter. Set it based on instructions provided in Table 1 GUC parameters.

Value range: an integer ranging from 0 to 20

Default value: 1

recovery_parse_workers

Parameter description: Specifies the number of ParseRedoRecord threads for the extreme Recovery Time Objective (RTO) feature.

This parameter is a POSTMASTER parameter. Set it based on instructions provided in Table 1 GUC parameters.

Value range: an integer ranging from 1 to 16

This parameter can be set to a value greater than 1 only when the extreme RTO feature is enabled. In addition, it must be used together with recovery_redo_workers. If both recovery_parse_workers and recovery_max_workers are enabled, the setting of recovery_parse_workers prevails and the concurrent replay function is disabled. The extreme RTO feature does not support the hot standby mode or primary/standby/secondary mode. Therefore, recovery_parse_workers can be set to a value greater than 1 only when hot_standby is set to off and replication_type to 1. This feature does not support column-store tables, either. Therefore, disable this feature in a system where column-store tables are used or are to be used.

Default value: 1

recovery_redo_workers

Parameter description: Specifies the number of PageRedoWorker threads corresponding to each ParseRedoRecord thread when the ultimate RTO feature is enabled.

This parameter is a POSTMASTER parameter. Set it based on instructions provided in Table 1 GUC parameters.

Value range: an integer ranging from 1 to 8

This parameter must be used together with recovery_parse_workers, and it takes effect only when recovery_parse_workers is set to a value greater than 0.

Default value: 1

recovery_parallelism

Parameter description: Specifies the actual number of replay threads. This parameter is read-only.

Value range: an integer ranging from 1 to 2147483647

This parameter is affected by the parameter: recovery_max_workers and parameter: recovery_parse_workers. When any of the above parameters is greater than 0, the parameter value will be recalculated.

Default value: 1

enable_page_lsn_check

Parameter description: Specifies whether to enable the data page LSN check. During replay, the current LSN of the data page is checked to see if it is the expected one.

This parameter is a POSTMASTER parameter. Set it based on instructions provided in Table 1 GUC parameters.

Value range: Boolean

Default value: on